What are the C and V buttons on Nitecore charger?
Holding down both “C” and “V” buttons will initiate the battery recovery process, this is designed to recover over-discharged IMR batteries, even when voltage is measured at 0V. The NEW i4 automatically adopts the optimal current to charge any compatible batteries upon installation.
What does the red light mean on a Nitecore charger?
When on fast-charging mode, the red light on top will turn on then charging current will be set at 1.5A. “V” button is to be pressed to select charging terminated voltage. This can be set at 4.35V or 4.2V or 3.7V.
How long does it take to charge batteries on the Nitecore charger?
approximately 2 hours
Per single slot the UM2 has a maximum output of 1500mA, which means a 3500mAh 18650 battery takes approximately 2 hours to reach 80% charge. The Nitecore UM2 has an LCD display which relays real-time charging information.
How do you use a Nitecore charger?
Install batteries: Put one or two batteries in each independently-controlled slot according to the polar mark on the charger. Battery identification: Four LEDs go up over the slot a Lithium battery is inserted in; two lower LEDs go up over the slot a Ni-MH battery is inserted in. Charging begins in two seconds.
How do I turn on my Nitecore flashlight?
Press the tail switch partway to turn on the flashlight, and release to turn it off. To turn the TM03 on, press the tail switch until a “click” is heard. To turn the TM03 off, press the tail switch again until a “click” is heard.
How do you use the Nitecore um2 charger?
During the charging process: Short press the C button to cycle through the charging status of the 2 slots. Short press the V button to cycle through Charging Current, Battery Voltage, Charged Volume and Charging time on the LCD screen. Long press the C button to enter the Charging Setting Mode.
How do I turn off Nitecore?
With the light turned off, press the mode switch twice in quick succession to enter strobe mode directly. To exit, simply press any switch to turn the light off. With the light turned on, press and hold both switches for over one second to switch the light off and enter lockout mode.
How do I reset my Nitecore i2?
Lithium Battery Recovery Press and hold both buttons until its power indicator blinks to enter the Recovery mode. Nitecore recommends abandoning this battery if it fails to be recovered after several attempts. NOTE: Do not conduct battery activation operation when batteries are inserted with reversed polarity.