How do I configure HT801?

How do I configure HT801?

Installing Grandstream HT801 ATA Devices

  1. Capture the device’s IP Address. Plug in an analog handset into the phone jack, go off-hook, listen for dial tone and dial “***” (three * tones).
  2. Reset the HT801 ATA to factory default.
  3. Configure the Grandstream HT801 ATA.
  4. Click the Advanced Settings menu.

How do I find the IP address of my Grandstream HT801?

OBTAINING HT801 IP ADDRESS The HT801 is by default configured to obtain the IP address from DHCP server where the unit is located. In order to know which IP address is assigned to your HT801, you can access to the “Interactive Voice Response Menu”.

How do I install an ATA device?

How to Install a Serial ATA Hard Drive

  1. Power down the computer.
  2. Open the computer case.
  3. Install the hard drive to the drive cage.
  4. Connect the Serial ATA cable to the primary or secondary Serial ATA connector on the motherboard or PCI card.
  5. Attach the other end of the Serial ATA cable to the hard drive.

How do I access my Grandstream web GUI?

Accessing Web GUI

  1. Open a web browser and enter the IP address into the address bar in the following format: https://ipaddress:8089 (The IP address is displayed on the LCD screen of the Grandstream)
  2. Depending on your browser, you may receive a warning about the security certificate.

What is the default password for Grandstream HT802?

admin
The default administrator password for the HT802 is admin.

How do I factory reset my Grandstream HT802?

Factory Reset the Device

  1. Plug in and power on the ATA device.
  2. Locate the indented RESET button between the power and ethernet port.
  3. Use a paper clip or toothpick to press and hold the reset button for 10 seconds. Do not release the button until all 4 lights on the top of the ATA flash for 1-2 seconds.

How do I setup my Grandstream device?

Guide: How to Set Up a Grandstream GXP2160

  1. Step 1: Get the IP of the phone. While you can setup everything through the display on the phone, it is a lot easier to manage through your web browser.
  2. Step 2: Log on to the phone’s web interface.
  3. Step 3: Set up your account.
  4. Step 4: Enter Network Settings.
  5. Step 5: Set Presence.

What is the difference between SATA and ATA?

SATA cables are thinner, more flexible and less massive than the ribbon cables required for conventional PATA hard drives. The SATA protocol replaced the Parallel ATA standard that required a parallel connection. SATA transfers individual bits of data in serial fashion.

Where does ATA cable plug into?

Connect the Serial ATA cable to the primary or secondary Serial ATA connector on the motherboard or PCI card. The drive can be plugged into either. If the drive will be used as a boot drive, select the primary channel, as this is the first drive to boot between the Serial ATA connectors.

How do I update my Grandstream firmware?

1- Access the web GUI of your device and navigate to “Upgrade and Provisioning” settings: 2- Make sure to select “Always Check for New Firmware” 3- Select Upgrade via TFTP 4- Enter the path of your TFTP server containing the firmware file under “Firmware Server Path” 5- Press “Save and Apply” at the bottom of the page …

How do I find the IP address of my Grandstream HT802?

Pick up the phone connected to the HT802 and dial the * key on your phone 3 times. Have a pen and paper ready. When you hear the message – Enter a menu option please enter 0 2 on your phone. You will now hear a message giving you the IP address of your HT802, such as: “192.168.

Q&A