What is a scaffold transom?
Transoms are horizontal load-bearing scaffold components for supporting planks. Available in sizes between 0.7M to 2.4M that can hold 3 to 10 planks. Testing is done on central load points to ensure all scaffold transoms can load-bear tools, materials, and personnel.
What is intermediate transom?
This Transom is used to support scaffolding boards in every bay at 1.2mt centre supports.
What are the 2 types of scaffolds?
Following are types of Scaffolding in construction: Suspended scaffolding. Trestle scaffolding. Steel scaffolding.
Does a scaffold need a Scafftag?
Q. Must I use a tag system on a scaffold? A. Although tag systems are not a legal requirement, the law does require inspection of scaffolding from which a person might fall 2 metres or more and the issue of a report by a competent person, on completion and at least weekly thereafter.
What is the purpose of a Scafftag?
The purpose of a scafftag is to communicate test status, identify when testing is due and to record and audit trail. The combination of this makes sure that accidents are reduced in the workplace.
Does all scaffold need a Scafftag?
SCAFFTAG. Although not a legal requirement, the SCAFFTAG/SAFETRAK system provides for continuous safety control over a scaffold. An up to date SCAFFTAG displayed on a scaffold helps to demonstrate compliance with the appropriate safety procedures.
What are the regulations for scaffolding?
Requirements for general access scaffolds. Scaffolds must be designed, erected, altered and dismantled only by competent people and the work should be carried out under the direction of a competent supervisor. All scaffolding must be erected, dismantled and altered in a safe manner.
Do I need intermediate transoms for scaffolding?
Additional intermediate transoms may be required to support shorter boards. When the platform is no longer required the intermediate transoms can be removed and used elsewhere on the scaffold. Transoms or putlogs should be laid no more than 1.2m apart if used for supporting 38mm scaffold boards.
How are the length of the transoms of a scaffold determined?
The actual length of the of the transoms or putlogs is determined by the width of the working platform, this width is determined by the by the intended use of the scaffold. Working platforms should have a minimum width of 600mm. Main transoms are an integral part of a scaffold structure that holds the two rows of standards in position.
What is a ledger in scaffolding?
Ledgers are the horizontal tubes which connect with and support the standards. Ledgers also act as supports for transoms and will usually run in the direction of the larger dimension of the scaffold. Depending on the intended use of the scaffold will determine the vertical spaces or distances between the ledgers.
What is an intermediate transom on a lift?
Intermediate transoms are used for extra board support when a lift is to be boarded over as a working platform. The intermediate transoms are usually laid across ledgers in the centre of each bay, fixed with putlog couplers. Additional intermediate transoms may be required to support shorter boards.