What does the AudioControl LC2i do?
The LC2i, is a compact, two-channel processor with active input circuitry, which allows it to accept speaker-level signals of up to 400 watts per channel from factory-installed source units or amplifiers.
Can I run 2 amps from an LC2i?
Yes, for the amp you can just connect it to the LC2 for the input.
Does LC2i need a fuse?
The LC2i requires a +12V in order to run properly. For best results, the +12V should be provided by the battery via direct line or from a power distro-block. The preferred wire gauge for the connection is a 18 AWG, and a 1A fuse is recommended.
What is the best line output converter for audio control?
AudioControl LC2i PRO, 2 Channel Line Output Converter with Impedance Matching, AccuBASS & GTO, Audio Signal Sense, 12 V Turn On and ACR-1 Dash Remote Subwoofer Control The AudioControl LC2i PRO joins ranks with AudioControl’s most popular active line output converter, the LC2i. Adding a sub? Planning a full system?
What is the AudioControl lc2i pro?
AudioControl LC2i PRO, 2 Channel Line Output Converter with Impedance Matching, AccuBASS & GTO, Audio Signal Sense, 12 V Turn On and ACR-1 Dash Remote Subwoofer Control The AudioControl LC2i PRO joins ranks with AudioControl’s most popular active line output converter, the LC2i.
How do I dial in my amp (s) with the lc2i?
The LC2i accepts the factory high level inputs and converts it to RCA to drive your amp. If you go to the Audiocontrol web site you can get much better instructions on how to set your levels; the instructions on the package card stock are a little lacking. Once the output level of the LC2i is set, dialing in your amp (s) is a breeze.
How does the ACR-1 control the bass output?
The ACR-1 is a great way to control the Bass Output level being sent to your subwoofer amplifier. The ACR-1 ONLY controls the level of the Bass Output and is strictly an attenuator knob. The ACR-1 will NEVER increase the Bass Output level past where Bass Output Level knob is set.