What is HP ProCurve Switch?
The HP ProCurve Switch 2800 Series consists of two switches: the 24-port HP ProCurve Switch 2824 with 20 10/100/1000 ports, and the 48-port HP ProCurve Switch 2848 with 44 10/100/1000 ports. In addition, each switch has four dual-personality ports for RJ-45 10/100/1000 or mini-GBIC connectivity.
How do I console my HP switch?
To connect a console to the switch, use the console cable shipped with the switch and connect a PC or VT-100 terminal to the console serial port….
- Reconfigure the switch and save the new settings.
- Reconfigure the terminal and save the new settings.
- Reboot the switch and re-establish the console session.
How do I configure my HP switch ports?
Enabling or disabling ports and configuring port mode (CLI)
- You can configure one or more of the following port parameters.
- See Status and parameters for each port type.
- To configure port C5 for auto-10-100, enter this command: HP Switch(config)# int c5 speed-duplex auto-10-100.
How do I factory reset my HP switch to command line?
Switch to the configuration context with the command config. Erase all user information and configuration, restoring the switch to its factory default state with the command erase all zeroize. Enter Y when prompted to continue. The switch automatically restarts.
How do I check my HP switch settings?
To display the running configuration using the WebAgent:
- In the navigation pane, click Troubleshooting.
- Click Configuration Report.
- Use the right-side scroll bar to scroll through the configuration listing.
How do I pass VLAN on HP switch?
To assign an access port (in interface view) or multiple access ports (in port group view) to a VLAN:
- Enter system view, use the command: system view.
- Enter interface view or port group view. Enter Layer 2 Ethernet interface view.
- Configure the link type of the ports as access.
- Assign the access ports to a VLAN.
What is a hybrid port on HP switch?
HP Switch – Hybrid port configuration on CLI A switch port in hybrid mode combines the characteristics from the access mode and the trunk mode to allow traffic of multiple vlans, which might be tagged or not.
What is the command to reset a switch?
Hold the “mode” button on the front of the switch for 10 seconds. The lights will blink then go solid – the switch completely wipes all configuration and then reboots.
How much does an HP j4903a cost?
J4903A HP Used (2) from $129.95+ $10.49 shipping Customers also viewed these products Page 1of 1Start overPage 1 of 1 Previous page NETGEAR 5-Port Gigabit Ethernet Unmanaged Switch (GS305) – Home Network Hub, Office Ethernet Splitter, Plug-and-Play, Silent Operation, Desktop or Wall Mount 4.8 out of 5 stars 35,529 25 offers from $14.31
Is a layer 3 switch a router or switch?
This is how a layer 3 switch acts as both a switch and a router. Often referred to as a multilayer switch, a layer 3 switch adds a ton of flexibility to a network. The features of a layer 3 switch are:
What are the disadvantages of a layer 3 switch?
Layer 3 switches are most applicable only for large intranet environments with many device subnets and traffic. Homes and small organizations do not need these switches. Lack of WAN functionality is another major disadvantage with layer 3 switches.