How do I reset my hand scanner?
Reset your Bluetooth Barcode Scanner
- Turn on the barcode scanner.
- Press and hold the trigger button while pressing the power button. After 15 seconds, the scanner will beep.
- Release the trigger button. The scanner will beep 5 times and power off.
- Turn the scanner back on and scan the barcode below:
How do I test a barcode scanner?
Print your barcode and take it to a retail store. Ask if you can scan your barcode at the register. (Bribe the cashier with snacks.) The scanner should pick up your barcode and beep, confirming that the barcode is readable.
Why My scanner is not working?
First check your connection to the scanner and computer: Make sure your scanner’s AC adapter is securely connected to the scanner and a working electrical outlet. Make sure the interface cable is securely connected to the scanner and your computer, and that the cable is not damaged or crimped.
How do I get my scanner to work?
Check the cable between the scanner and your computer is firmly plugged in at both ends. If possible, switch to a different cable to test for problems with the existing one. You can also switch to a different USB port on your computer to check if a faulty port is to blame.
How do I check my scanner connection?
Verify your scanner is installed
- Select Start > Settings > Devices > Printers & scanners. Open the Printers & scanners settings.
- Under Printers & devices, look for your scanner.
Who is a Datalogic Skorpio™ mobile computer user?
“User” refers to anyone using a Datalogic Skorpio™ mobile computer. “You” refers to the System Administrator or Technical Support person using this manual to install, configure, operate, maintain or troubleshoot a Datalogic Skorpio™ mobile computer. REFERENCE DOCUMENTATION
What are the conventions of the Datalogic manual?
This manual uses the following conventions: “User” refers to anyone using a Datalogic Skorpio™ mobile computer. “You” refers to the System Administrator or Technical Support person using this manual to install, configure, operate, maintain or troubleshoot a Datalogic Skorpio™ mobile computer.
How do I remove the battery pack from the Datalogic Skorpio™?
Turn off the Datalogic Skorpio™ and remove the battery pack, by turning its lock screw to the open position (horizontal) and pulling the lock runner up. 3 DATALOGIC SKORPIO™
How do I connect Datalogic Skorpio™ to an Ethernet network?
In order to avoid wasting power, all modules are off by default. 30 USE AND FUNCTIONING 3 3.7.5 Ethernet Settings Datalogic Skorpio™ can be connected to an Ethernet network by inserting it into the Datalogic Skorpio™ Ethernet Multi Cradle. NOTE Ethernet communication requires Datalogic Skorpio™ SW version 5.41 or later.