How do you add sensors to Simon XT?
Wireless sensors are assigned to a wireless zone on the Simon XT System. Therefore, adding a wireless zone is essentially the same thing as adding a wireless sensor. To add a sensor, keep pressing the down arrow in the System Programming Menu until the option “Sensors” is displayed. Then press the “OK” button.
How do you put Simon XT in test mode?
Simon XT – Sensor Test
- Press until Sensor Tests then press.
- Enter Master Code then press.
- Open door or window, walk by motion detector, or press key fob button.
- Simon XT beeps 1 to 8 times indicating signal strength.
- Sensor Tests exits when all sensors are tested or by pressing STATUS.
How do you add sensors to the Simon XT?
How do I remove Simon XT from wall?
Simon XTi – Panel Wall Mounting
- Insert a coin into the bottom right slot to pry the trim ring off front cover.
- Remove the trip ring from the front of the Simon XTi.
- Lift up on the two tabs at the top of the panel to open the cover.
- Swing the cover from the back plate.
How do I bypass Simon XT?
How do I bypass sensors with the Simon XT Control Panel?
- Open the door or window that you would like to bypass and leave it in the open position.
- Arm the system at the control panel in either Stay or Away Mode.
- Press the Bypass button on the Control Panel once it begins to protest that specific sensor is opened.
What type of battery does a ITI Simon XT use?
The GE Security Simon XT alarm battery set includes 1 battery – SP6-1.2 (6 V 1.4 AH).
How do I change the battery in my Simon XT panel?
Simon XT – Replacing Panel Battery
- Go to your keypad and press down on the two tabs on the top of the keypad.
- Cover will swing down revealing battery inside.
- Take new battery and replace leads pairing black with black and red with red.
- Place batter back into the panel, leads down.