Why is it necessary to check the jumper setting of the IDE drives?
For IDE hard drives, it’s important to properly set the jumpers. If not properly done, your computer may not boot or the hard drive won’t be detected. If more than one device is on an IDE port, one device must be set to primary and the other set to secondary or cable select.
What is jumper setting?
When you set a jumper, you place a plug on the prongs that completes a contact. In effect, the jumper acts as a switch by closing (or opening) an electrical circuit. Jumpers can be added or removed to change the function or performance of a PC component. A group of jumpers is sometimes called a jumper block .
Why does my external hard drive not show up?
If the drive still isn’t working, unplug it and try a different USB port. It’s possible the port in question is failing, or just being finicky with your specific drive. If it’s plugged into a USB 3.0 port, try a USB 2.0 port. If it’s plugged into a USB hub, try plugging it directly into the PC instead.
What is the jumper setting?
In electronics and particularly computing, a jumper is a short length of conductor used to close, open or bypass part of an electronic circuit. They are typically used to set up or configure printed circuit boards, such as the motherboards of computers. The process of setting a jumper is often called strapping.
What does jumper on motherboard for?
In a computer, a jumper is a pair of prongs that are electrical contact points set into the computer motherboard or an adapter card . When you set a jumper, you place a plug on the prongs that completes a contact. In effect, the jumper acts as a switch by closing (or opening) an electrical circuit.
What is jumper in transmission line?
A jumper is a conductor that is rated to carry full line (load plus capacitive charging) current and is installed to connect line spans on opposite sides of a deadend or a large angle structure. The jumper is installed on each phase of the line and operates at full line voltage.