What is Wiremold Raceway?
Wiremold® Raceway has defined the cable raceway category as an alternative to electrical conduit for close to a century. Attractive, cost-effective and an easy way to bring cables and wires to where they’re needed—in virtually any room.
Can you use metal Raceway outside?
Also, the NEC (National Electrical Code) rates surface metal raceways for dry locations only. So, while it is easy to install and less visually intrusive when seen running along a wall than conduit, it should not be used outdoors.
Who makes Wiremold?
Legrand SA
In July 2000, French electrical manufacturer Legrand SA acquired the Wiremold Company for $770 million. Wiremold now works in cooperation with Ortronics, Inc, a Legrand-owned sister company based in New London, Connecticut.
What are Wireways used for?
Wireways are commonly used for incoming cable runs and feeder circuits from switchboards to power and lighting panels, distributing power in industrial plants, and ganging equipment.
Does Exposed Romex need to be in conduit?
Code and common sense both dictate that Romex shouldn’t be left exposed but must run through conduits. If you are running it through the basement or attic (or both), the wire must past through studs or be secured on top of joists or trusses.
What are the two types of Wireways?
Image credits:
- Lay-in Wireway.
- Feed-Through Wireway.
- Wiring Trough.
Can you run Romex in Wiremold?
Senior Member. Yes, NM cable is permitted in metal and nonmetallic surface raceways; however you must check the manufacturer’s instructions for permitted number of conductors or cables and what cables and conductors are DESIGNED to be installed. Yes, the occupancy type makes a difference.
What is the disadvantage of using cable tray?
The solid bottom cable tray system has a disadvantage. In that moisture can build up in the cable trays.