How do you join two kitchen worktops?
If joining wooden worktops, we would recommend using a butt joint to connect the two work surfaces together at a 90˚ angle using specialist worktop connector bolts. To accommodate the bolts, you would need to cut recesses into the underside of the worktop, which is easiest done with an electric router.
What do you use to join worktops together?
A butt joint is used to connect two worktops at a 90° angle and so are simpler and easier to join together compared to mason’s mitre joints. Three apertures are routed into the underside of the of the worktop to allow for connector bolts to be fitted and, when tightened, create a smooth finish.
How do you hide laminate seams?
Apply a small amount of seam filler on the plastic plate. Use your putty knife to mix the filler until the color is consistent. Scoop putty onto the edge of your putty knife and drag the knife across the seam. Repeat this step until the seam is filled.
Can you screw compact laminate?
Cutting screw threads in compact laminate is straightforward. Self- tapping screws can also be used without a problem. Screws with a slow thread are recommended as they achieve a better pull-out resistance. Pre-drilling is essential in all cases.
How do you finish compact laminate edges?
Edging. Unlike traditional laminate surfaces, solid laminate worktops do not require edging strips. To finish or re-finish edges, simply sand with 240 grit sanding paper to soften the edge. It is recommended that a small amount of linseed oil is applied to cut edges to achieve a smooth finish.
Can you use silicone to join worktops?
To ensure a permanent and watertight joint, a suitable sealer should be used on the worktops. We recommend either a standard clear silicone sealant or a colour matched Unika ColorFill joint sealant. This should be applied to both joint ends prior to connecting the worktops together.
Can you cut compact laminate with a hand saw?
A hand-held plunge saw with a TCT triple chip blade is suitable for cutting compact laminate. An alternative might be a jigsaw with a selection of metal cutting blades.
How do you join two laminate worktops without a jig?
If you would like to join a laminate worktop without a jig, our mason’s mitre joint fabrication cutting service is perfect. Mason’s mitre joints, also known as a butt and scribe joint or hockey stick joint, waste less material when compared to a 45° mitre joints and are regarded as the best method for joining two laminate worktops.
How do you join two pieces of laminate flooring?
This is created by using a powerful router with a half inch collet (which holds the cutter), at least 1800 Watts, and a worktop jointing jig. This shapes the two pieces of laminate to fit snugly together by mitreing the first 30mm to 35mm at 45° then shaping the rest of the joint so it is parallel to one of the walls.
How do you cut laminate countertops for kitchen worktops?
Measure and cut the laminate countertops to the desired size. When connecting two pieces along a run, such as in a galley kitchen, make the cuts straight across at a 90 degree angle. For joining in a corner, the pieces should be cut at a 45 degree angle. Sand down any rough edges with a sander or file.
How do you join two worktops with a router?
Instead of using a strip, we recommend using an electric router and one of our worktop router jigs to cut a mason’s mitre joint (sometimes known as a hockeystick joint). This type of joint creates a very clean connection between the two worktops that is sealed to create a very inconspicuous join.