How do I find the model number of my Lutron?
With Lutron dimmers/ switches the model number can be located on the side of the device on a white label. If you are unable to find the white label on the side of the dimmer, there are a select few devices where the model number would be stamped on the front of the yoke.
How do you reset a Lutron Maestro dimmer switch?
How to Reset a Lutron Maestro
- Inspect the dimmer switch panel. The large rectangular button in the center is the dimmer switch button.
- Push and hold the dimmer switch. While holding it, push the air gap switch back upward to turn it back on.
- Continue to hold the dimmer switch for 15 seconds.
What does a companion switch do?
Wired Dimmer and Switch Companions pair with Decora Smart Dimmers, Switches or Fan Speed Controls to provide additional lighting control where needed, such as at the base of a staircase, the end of a hallway or open areas with multiple entrances that have existing 3-way or more control.
What does a LUT MLC do?
The Lutron LUT-MLC is a minimum load cap that ensures proper function when fluorescent, CFL, or LED loads are used. Install the LUT-MLC Inside a load fixture or in a separate j-box within the circuit.
Why is my dimmer switch not working correctly?
If your dimmer switch suddenly stops working, there could be issues with the electrical wiring. If it’s not installed correctly or the wires come loose, the switch might stop working. You might hear a buzzing or crackling sound if wiring is the issue. When you suspect a wiring issue, hire an electrician to inspect it.
How do I reset my LED dimmer switch?
Turn the lights OFF and back ON three times: OFF-ON-OFF-ON-OFF-ON (leaving approx. 1 second between presses). The light will come ON and dim down to OFF indicating a successful factory reset. Then the light will flash once showing the dimmer has returned to default MODE 1 (trailing edge).
Why is my LED ceiling light flashing on and off?
But most commonly, LED bulbs may flicker or dim in your home when there are voltage fluctuations in your home’s wiring. When electrical loads turn on and off in your home, this creates a change in voltage levels, which may cause the LED lights to occasionally dim or flicker.
Does a dimmer switch need special wiring?
New dimmers have either a green grounding wire or a green ground screw that you’ll have to connect to a grounding source if one is available. Houses wired with plastic-sheathed cable almost always have bare copper ground wires that you’ll connect to the toggle dimmer switch.
Can one dimmer switch control 2 lights?
With a standard single-pole dimmer, a single switch controls the light. With a three-way dimmer, you can control a light with two switches. You will need a three-way dimmer and a three-way switch. This lets you dim from one location and turn the lights on and off from another.