How do I turn off my Axia Lo Carbon vent?
Continuous Trickle operation Press the S-button until the “CONSTANT” light comes on. Select the fan speed using the SPEED buttons. To turn off continuous trickle operation: press the S-button until the “CONSTANT” light goes off.
What does a Vent Axia Lo carbon do?
Through-The-Wall Heat Recovery Unit The Vent-Axia Lo-Carbon Heat Save uses a reversible fan to extract dirty air from the room and replace it with outside air 70 seconds later. This air passes through a filter to ensure that clean air enters the room.
How does a Vent Axia fan work?
The whole house system works by replacing the warm stale moist air from the house, with fresh air from outside. The fresh air passes through a highly efficient heat exchanger and is prewarmed by the heat which is recovered from the extracted air. The heat exchanger recovers up to 70% heat from the outgoing stale air.
How do I set the timer on my Vent Axia fan?
The timer can be activated by removing the Jumper JP1, this will give the fan a fixed over run time of approx. 15 mins. BEFORE ADJUSTING THE CONTROLLER, SWITCH OFF THE MAINS SUPPLY. HUMIDISTAT SHOULD ONLY BE ADJUSTED BEFORE OR DURING INSTALLATION.
What is a lo carbon fan?
The new Lo-Carbon Silent Fan Range from Vent-Axia not only delivers stylish and silent ventilation without compromise on performance, but now comes with even more features and more model options providing flexibility when choosing the right fan.
What is a low carbon extractor fan?
The Vent-Axia Lo Carbon Centra Extractor Fan is low voltage and has an overrun timer. It is a dual speed continuous running fan for kitchens, utility rooms, bathrooms and toilet, with trickle speed selection at installation. Switch live to boost with linked in overrun timer (adjustable up to 30 minutes).
How do I adjust my extractor fan timer?
This time delay can be increased by firstly switching off the power to the fan. Remove front cover and the timer cover as detailed. Insert a small screwdriver into the slot marked . Turn clockwise to reduce the time and anti-clockwise to increase the time.
What is dMEV?
dMEV – decentralised Mechanical Extract Ventilation – is a whole house ventilation methodology which consists of extract fans and background ventilators which are fitted in bathrooms and kitchens, running continuously at low trickle speeds to draw moisture-laden air out of the home.
How long should extractor fan run on for?
According to the Home Ventilation Institute (HVI) the exhaust fan should run for at least 20 minutes after the shower has been used. This ensures that the proper amount of ventilation has occurred.
Should a bathroom fan run all the time?
Experts agree that you should not leave your bathroom fan on all night. You should only run the fan for about 20 minutes during and after a bath or shower. You especially shouldn’t leave it on at night. If it’s run too long, it can cause serious problems and become a fire hazard.
What should my humidistat be set at?
So to be safe, we recommend setting your humidistat’s relative humidity (RH) to 58 percent and setting your thermostat temperature between 77 and 80 degrees Fahrenheit. These settings will not maintain your selected temperature indoors but will maintain 58 percent humidity.
Do you need trickle vents with dMEV?
Where trickle vents need to be installed in all habitable rooms and in combination with dMEV, airflow is established throughout the dwelling more effectively than with PIV. dMEV offers localised control whereas PIV airflow is supplied centrally to the home and relies on building permeability for adequate circulation.
Is the Vent-Axia Lo-carbon Tempra a heat recovery fan?
DESCRIPTION Through the wall Heat Recovery Fan The Vent-Axia Lo-Carbon Tempra is suitable for refurbishment or new build, kitchen, bathroom, toilet or utility applications. The unit meets the performance requirements for intermittent extract fans under the Building Regulations Part F 2010 (table 5.1a) and also for continuous running products.
Why Vent-Axia Lo-carbon centra?
The attractive and discreet styling of the Vent-Axia Lo-Carbon Centra will complement the décor of any new home while virtually silent operation ensures optimum ventilation is achieved without intrusive noise. dMEV version recognised in SAP PCDB. Lo-Carbon Centra has a specific fan power of only 0.18 W/l/s in through-the-wall kitchen applications.
How do I Clean my Vent-Axia heat exchanger?
Remove Retaining Plate, Carefully slide out the Heat Exchanger Fig 25 & 26 and wash in warm water using a mild detergent, dry thoroughly and re assemble in reverse order to above. 9 Fig.21 Fig.22 Fig.24 Fig.25 Fig.26 Fig.23 E. Spares The following spares may be ordered from Vent-Axia Item Part No Description Models used 1.
Are there any accessories available for Vent-Axia Lo-carbon IQ?
ACCESSORIES There are a number of accessories available for Vent-Axia Lo-Carbon iQ to help you as user install the product as smoothly as possible. For the full range of accessories see www.vent-axia.com For optimum ventilation, you must ensure that sufficient air can enter the bathroom.