How do I use my AT uverse remote?
Here’s all you need to do:
- With your TV on, use your U-verse TV remote and press Menu.
- Select Help > Information > Remote Control Setup.
- Next, select your remote control from the TV onscreen list. Refer to your specific remote for TV/device setup options.
- Select Top Ten Brand Setup, Automatic Code, or Manual Setup.
How do I reset my uverse remote control?
Reset your remote by type and clear any programming Enter programming code 900 by pressing the number keys on the remote control. The AT key will give a long flash, indicating the code was successfully entered and the remote has been reset to the default settings.
What is the ATT button on my remote?
Check the mode buttons – For all but the S20 and S30 remotes, select the AT mode button on your U-verse TV remote to control the U-verse TV receiver, which gives you access to the Menu, Channel Guide, and channel functions.
Why is my ATT Uverse remote not working?
Restart your receiver – Hold down the POWER button for 10 seconds then press it again to restart. This process will take 5-8 minutes and will impact any DVR recordings in progress. Order a replacement remote – visit the online Accessory store to order a replacement U-verse TV remote control.
Why is my AT remote not working?
Check cables – Check for a snug and secure connection of the video cables between your TV, Gateway, and your receiver. Also, make sure your TV’s input settings match the type of cable you are using. Restart your receiver – Hold down the POWER button for 10 seconds then press it again to restart.
How do I know if my IR receiver is working?
You only need to connect a voltmeter to the IR diode and the remote control tester is finished. Set the multimeter so it measures DC voltage and turn it on. Hold the remote control close to the IR diode and push any button. If the remote control is working then the voltage shown on the display will quickly rise.