How do I reset my digital pool pilot?
How do I recalibrate my Pool Pilot® Digital for salt?
- Press MENU button.
- Press Arrow UP to MAINTENANCE MENU, then press SELECT.
- Press Arrow UP to CALIBRATE SALT, then press SELECT.
- Adjust the salt display to match the reading of your test by pressing the Arrow UP or DOWN.
How many amps does a salt chlorinator use?
Most units use between 6.2 Volts dc and 9.2 Volts ac and operate between 10 and 30 Amps. To control the operation of the cell – i.e., provide switching, water flow monitoring, gas sensing, etc.
How long does an AutoPilot cell last?
WRITTEN BY: Inyo Pools A salt chlorine generator cell will last about 3 -5 years before it has to be replaced. The following guide describes how to replace an AutoPilot Salt Cell.
What does Warning low amps cell mean?
High volts and low amps usually indicate a bad cell or cell cord. Low volts and low amps can be a blown cell fuse (top left corner of the circuit board), or a bad power module (the whole circuit board). Check the rest of your fuses while you have the top covers off.
What does low amps on salt cell mean?
If you have a Dig-36 or Mineral Springs Digital Saltwater Chlorinator, one of the most common errors is a ‘Low Amps’ message. This is typically a sign that the cell and cell cable have or are close to expiring.
What does low amp cell mean?
What does low amps cell mean?
How do you test a salt cell amp?
Phase 3: Check the amps….Low Amps on Salt System
- Turn your unit to 100%.
- Wait for 30 minutes.
- Press the menu button.
- Scroll to the test pool pilot menu.
- Press select.
- Allow the testing to scroll through. Pay special attention to the AMPS reading.
- The amps should be higher than 4.
How long should salt cell last?
about five years
This is all possible thanks to your pool’s salt chlorine generator cell. With proper care, a cell will last about five years. Eventually, though, it will need to be replaced. The trick is, it’s not always easy to know when it’s time.
What should salt cell amps be?
The higher the number, the better. The amps should be higher than 4. If the amps are reading lower than 4, replace the cell and cell cable.