How do you reset the oil maintenance light on a Toyota Sienna?

How do you reset the oil maintenance light on a Toyota Sienna?

Answer provided by

  1. Turn your key in the ignition to accessory mode.
  2. Locate and press the ODO/TRIP button until ODO comes up on the display.
  3. Turn off your Sienna.
  4. Hold down the ODO/TRIP button and start your engine while continuing to hold.
  5. When your odometer display reads all zeros, you have reset the maintenance light.

How do I reset my oil life?

Oil Change Indicator Reset

  1. Switch the ignition on.
  2. Fully press the accelerator and brake pedals at the same time.
  3. Keep the accelerator and brake pedals fully pressed.
  4. After three seconds, a message displays confirming the reset procedure is in progress.

How do you reset the oil light on a Toyota?

Put your key in the ignition and turn it to position one, the position just before starting the car. Push and hold the trip meter reset button on the dashboard, then turn your key to position two. Continue holding the odometer button for 10 seconds. The light should then flash, possibly beep, and then go out.

How do you reset the oil light on a 2010 Toyota Sienna?

2004-2010 Sienna Maintenance Required Light Reset

  1. Turn The Ignition ON. Don’t Start The Engine.
  2. Press The ODO/TRIP BUTTON To Display To ODO. image for reference only.
  3. Then Turn The IGNITION To OFF.
  4. Press And Hold ODO/TRIP BUTTON And Turn Ignition To The “RUN” Position.
  5. Then Turn The Ignition OFF.

How do you reset the oil change light?

How do you reset the maintenance required light on a Toyota?

How to Reset the Maintenance Required Light?

  1. Turn Your Vehicle on. Your key should be switched to the on position and look on your dashboard.
  2. Turn the Vehicle Off and Press the Trip Meter Reset Button.
  3. Turn the Vehicle Back on.
  4. Keep the Reset Button Pressed.
  5. Release the Reset Button.

How do you reset the oil maintenance light on a 2010 Prius?

Press the Trip button on the steering wheel to navigate to Trip A. Turn the vehicle off by pressing the push-button start once. Press and hold the mph button that’s right above the push-button start while pushing the push-button start twice. The screen should say resetting oil maintenance data.

How do I turn off the maintenance required light on my Toyota?

Push and hold the dashboard odometer button and turn the key to position two. Keep holding the odometer button until the maintenance light starts to flash. You might even hear beeping noises. The light should go out.

Blog